Test Standard:
IS-398 Part-1, IS-398 Part-4, IS-398 Part-2, IS-398 Part-5, IEC-1089

• Measurement of diameter of individual Aluminium wires and galvanized Steel wires
• Breaking load test for single strand
• Elongation Test
• Wrapping test
• Galvanizing test
• Measurement of lay ratio/ Direction of lay
• Breaking load (UTS) of complete conductor
• Surface condition
• Stress strain test on conductor & Steel Core

Test Standard:
IS-2141, IS-280, IS-12776

• Lay Length
• Freedom from defects
• Tensile strength
• Percentage elongation from single strand
• Measurement of diameter
• Galvanizing test i] Mass of Zinc coating ii] Uniformity of Zinc coating iii] Adhesion of Zinc coating
• Wrapping test

Test Standard:
IS-2486 Part 1, IEC-61284

• Visual examination
• Verification of Dimension
• Slip strength test
• Mechanical strength test
• Breaking load test
• Galvanizing test

Types of Suspension Clamp: Envelope Type

Test Standard:
IS-2486 Part 1, IEC-61284, IS-2629

• Visual examination
• Verification of Dimension
• Slip strength test
• Mechanical strength test
• Damage & failure load test
• Galvanizing test

Type of Conductor: Accessories Dead-end, Mid Span Compression Joint, Repair Sleeve suitable for All type of conductors including HTLS type Conductor

Test Standard:
IS-2486 Part 1, IEC-61284, IS-2121 Part 2

• Visual examination
• Slip strength test
• Mechanical strength test
• Damage & failure load test
• Galvanizing test

Test Standard:
IEC-61284, IS-2121 Part 3

• Visual examination
• Slip strength test
• Mechanical strength test
• Verification of Dimension
• Galvanizing test

Test Standard:
IS-2121 Part 1

• Visual examination
• Slip strength test
• Mechanical strength test
• Verification of Dimension
• Galvanizing test
• Tensile strength
• Wrapping test
• Bend test
• Resilient test

Test Standard:
IS-1608, IS-1500, IS-738, IS-5584, IS-9997

• Visual examination
• Dimensional Checking
• Tensile strength (1mm to 30mm dia)
• Elongation Test
• Hardness Test

Test Standard:
IS-4228 IS-4229

• Visual examination
• Dimensional checking
• Tensile strength
• Elongation

Test Standard:
IS-1608, IS-2062, IS-1786, IS-2062, IS-277, IS-2141

• Visual examination
• Dimensional checking
• Tensile strength (1mm to 30mm dia)
• Compression Strength (Only bars max.30)
• Elongation
• Yield strength
• Proof Stress
• Hardness Test

Test Standard:
IS-280

• Visual examination
• Dimensional checking
• Tensile strength
• Elongation
• Bend test
• Wrapping test
• Galvanizing Test

Test Standard:
IS-1573

• Coating Thickness

Test Standard:
IS-9708, IEC-61897

• Visual examination
• Dimensional checking
• Resonance frequency test
• Dynamic characteristics test
• Damper efficiency test
• Clamp slip test (Before Fatigue test)
• Fatigue test (up to 10 million cycle)
• Clamp Bolt Torque
• Mass pull off test
• Galvanizing test (Uniformity of Zinc coating)

Test Standard:
IS-5561

• Clamps: Tee Clamps, Palm connector, Terminal connector,bolted type connector,wedge connector,PG clamp
• Visual examination
• Dimensional checking
• Tensile test
• Torque strength test on bolted type connector
• Cantilever strength test on bus type connector
• Galvanising test